- Control your 12V DC devices using a motion sensor detector.
You can control LED, CFL and Regular 12V DC light bulbs.
Animal feeders can be controlled so it will not waste food when animals are not around.
Delay time is cumulative. So, if you the sensor keeps detecting movement it will not shut off. After the last movement is detected the sensors will shut off after 5 seconds.

- Delay time: After detecting movement the module will output a signal triggering the sensor to switch lights ON. Delay time is cumulative. So, if you the sensor keeps detecting movement it will not shut off. After the last movement is detected the sensors will shut off after 5 seconds.
- It will turn ON when brightness is less than 10 Lux.
- Don’t exposed the unit to direct sun light, wind, vibration, heater or air condition.
- Don’t fix it at a place where there are obstructing material (e.g. Glass, dense clothes) which Infra Red cannot get though.
- The first time the unit is powered, it will need about one minute for initialization. During this time the signal triggered by the module will not be stable. After one minute the module will work normally.
- The sensitivity for left-right direction is better than up-down direction, so please make sure the installation direction is left-right.

1.Detection range: 70°
2.Detection distance: 3m (MAX.<24°c)
3.Power source: 12V/DC
4.Maximum load: 30W
5.Working temperature: -10°c~+40°c
6.Duration time: 5 Seconds (cumulative) Ambient light: <10 lux
8.Detection motion speed: 0.6~1.5m/s
9.Working Humidity: <93%RH